o series am e o f1 - j z 1 w att | a c - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052e r 0 1 of 3 north america only picture coming soon features: models single output model input voltage (vac/hz) input voltage (vdc) full power t emperature range (oc) output voltage (v) output current max ( m a) maximum capacitive load ( f ) efficiency (%) ame o f1 - 5s j z 85 - 264/47 - 440 70 - 400 - 20 to +55 5 200 220 66 ame o f1 - 9s j z 85 - 264/47 - 440 70 - 400 - 20 to +55 9 111 100 67 ame o f1 - 12s j z 85 - 264/47 - 440 70 - 400 - 20 to +55 12 83 100 70 ame o f1 - 15s j z 85 - 264/47 - 440 70 - 400 - 20 to +55 15 67 100 69 ame o f1 - 24s j z 85 - 264/47 - 440 70 - 400 - 20 to +55 24 42 100 68 note: all specifications in this datasheet are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. i nput specifications parameters conditions typical maximum units current 115vac 120 ma 230vac 60 ma inrush current <2ms 115vac 9 a 230vac 15 a external fuse recommended slow blow type 1 a input d issipation no load 0.5 w input filter recommended external (pi) filter output specifications parameters conditions typical maximum units voltage accuracy full load, 5v output full load, others 8 5 % line regulation full load 1.5 % load regulation 5% - 100% load 2.5 % ripple & noise 20mhz bandwidth 120 mv p - p hold - up time (min) 115vac 40 ms 230vac 180 ms minimum l oad c urrent 5 % of max isolation specifications parameters conditions typical rated units tested i/o voltage 60 sec 3000 v ac isolation resistance >1000 m? general specifications parameters conditions typical maximum units switching frequency 60 khz over current protection auto - recovery 110 % of i out short circuit protection continuous short c ircuit restart auto - recovery operating temperature see derating curve - 40 to +85 c storage temperature - 40 to +10 5 c ? input: 85 - 264vac, 47 - 440hz or 70 - 400vdc ? i/o isolation 3000vac ? operating temperature - 40c to +85c ? ultra slim open frame sip ? low power consumption 0.5w ? over current protection ? continuous short circuit protection ? class ii power supply
o series am e o f1 - j z 1 w att | a c - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052e r 0 2 of 3 north america only general specifications (continued) parameters conditions typical maximum units t emp era ture coefficient 0.15 % / c cooling free air convection humidity 85 % rh weight 7 g dimensions (l x w x h ) 1.38 x 0.71 x 0.43 inches 35 x 18 x 11 mm mtbf >200,000 hours (mil - hdbk - 217f, ground benign, t=+25 o c) safety specifications parameters standards meets iec 60950 - 1 en 55022, class a & b , with external filter circuits, as referenced iec 61000 - 4 - 2, contact 4kv, criteria b iec 61000 - 4 - 3 , 10v/m, criteria a , with class b external filter, as referenced iec 61000 - 4 - 4 , 2kv /4kv , criteria b, with class a /b external filter referenced iec 61000 - 4 - 5, 1kv/ 2kv, criteria b, with class a/b external filter referenced iec 61000 - 4 - 6 , 10 vrms, criteria a , with class b external filter, as referenced iec 61000 - 4 - 8, 10a/m, criteria a iec 61000 - 4 - 11 , 0 - 70%, criteria b pin out specifications * dimensions * add capacitor between pin 5 & 7. application circuit below. derating * *power derating: - 40 to - 20 increase 1%/c pin single 1 ac n 3 ac l 5 +v sc 7 - v sc 10 - v output 12 +v output - 40 - 20 0 20 40 60 80 100 100 80 60 40 20 0 safe operating area 100 % load 110 - 240 vac or 100 - 340 vdc output power (%) 85 ambient temperature o c free air convection 55 85 (70 ) 11 0 (100 ) 264 (40 0) 100 80 60 40 20 0 safe operating area output power (%) free air convection at 25 c input voltage vac ( vdc ) 240 (340 ) 35 .00 (1.38 ) 18 .00 (0.71 ) 1.15 (0.05 ) 1.30 (0.05 ) 10 .00 (0.39 ) 5.08 (0.20 ) 11 .00 (0.43 ) 1.75 (0.07 ) 0.50 (0.02 ) note : unit : mm ( inch ) pin diameter tolerance : 0.10 (0.004 ) case tolerance : 0.50 (0.02 ) 1 3 5 7 10 12 27 .94 (1.10 )
o series am e o f1 - j z 1 w att | a c - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052e r 0 3 of 3 north america only 55 to 85 decrease 0.67%/c recommended emc class a external circuit: recommended emc class b external circuit: note: for safety compliance we recommend minimum pcb trace distance of 3mm, minimum distance between pcb traces of 6mm, primary to secondary circuit traces distance between minimum of 6.4mm. note: 1. datasheets are updated as needed and as such, specifications are subject to change without notice. once printed or downloaded, datasheets are no longer controlled by aimtec; refer to www.aimtec.com for the most current product specifications. 2. p roduct labels sho wn, including s afety age ncy certificatio ns o n labels, may vary based o n the date manufactured. 3. mechanical drawings and specifications are for reference only. 4 . all specifications are measured at an ambient temperature of 25c, humi dity<75%, nominal input voltage and at rated output load unless otherwise specifie d. 5 . aimtec may no t hav e conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. cas numbers and other limited information are considered proprietary and may not be available for release. 6 . this prod uct is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control syste ms or other suc h applic atio ns whic h necessitate specific safety and regulatory standards other the ones listed in this datasheet . 7 . warranty is in accordance with aimtec?s standard terms of sale available at www.aimtec.com . model c2 tvs 5 vout 150 f / 35 v 7v 9 vout 12v 12 & 15 vout 1 0 0 f / 35v 20v 24 vout 30v ac dc ac ac a c c ac c c c c ac dc ac ac d a c c ac c c c c c ac d c ac c ac
|
